Check Out The Peugeot Keys Tricks That The Celebs Are Using

Peugeot 208 Key Replacement

It is recommended to leave the replacement of Peugeot keys 208 to auto locksmiths with the equipment and expertise. They can program and create keys more quickly and at a lower cost than a dealership.

If your key fob has stopped locking or unlocking your doors, it is likely due to a dead coin battery. But, there are other reasons that the key may be malfunctioning.

Dead Coin Battery

A dead coin battery will stop your Peugeot 208 from locking or unlocking and will not start the engine. In this case you'll need make use of the alternative method for starting that is described in the owner's manual.

The spark plugs might also be worn out. The spark plugs are responsible to ignite the fuel that ignites the engine. They have a limited life span. They'll eventually fail in the event that they aren't utilized enough.

Luckily, there is an easy solution for this problem. The best solution is to test the voltage of your car battery using a multimeter. If the voltage is lower than 11,5 volts then it's time to replace it. If the battery is corroded, it is important to clean its contacts. This can be accomplished by taking off the rubber covers from the two terminals of the battery, and then using a wirebrush to eliminate any parts of the battery that are corroded. It is then time to reconnect the cables to the positive and negative poles.

Water Damage

If your 208 won't turn on and the battery isn't flat, then you need to make sure whether the spark plugs work. You may find that they're dirty and do not spark. This can be fixed by cleaning the spark plugs in a workshop.

Peugeot cars use keys that are transponder-type and integrates with the car's immobiliser system. This ensures that only the correct key can start the engine. If the chip in the Peugeot key is damaged then it will not transmit the proper signal to the vehicle.

Water damage is the most common cause of this issue. This is a typical issue in colder climates where the vehicle is exposed to rain or snow. If this is the case, you should contact a reputable auto locksmith who has all the tools and equipment needed to reprogram the new key. They'll also have the latest technology and machinery needed to make a Peugeot smart key. The process shouldn't be more than 15 minutes.

Contacts to the battery are not working properly.

Peugeot changed from the carbon-encased transponder chips to an entirely new kind of chip that utilizes electronic components that are placed on circuit boards. The new system is effective when it's brand new, but over time the circuit boards start to deteriorate and stop working properly.

This could prevent the immobiliser from triggering so that your vehicle will not start. If this happens, it's a good idea to seek out a Peugeot specialist or locksmith.

The most frequent issue is when the battery in the key fob starts to fail. This causes the blade of the key to stop feeding into your lock. A locksmith for cars will replace the battery, and then cut a fresh blade for you. This is a quick fix.

Faulty Receiver Module

If your Peugeot key fob was not working after dropping it on the floor, getting exposed to a sudden rain or accidentally washing it the wrong way, it could be due a malfunctioning receiver module. The receiver module is responsible for transmitting radio frequencies to the onboard computer which controls the central locking system of your Peugeot vehicle.

The key fob itself has rubber seals that prevent water from reaching the chip inside. The chip can be damaged by water if it is exposed to water for a prolonged period of time. Submerging the key fob into ocean water on the beach or throwing it into the pool can be especially damaging because of the high salt content.

If your Peugeot spare key fob doesn't work, you'll need to have the module replaced. This is only done by a Peugeot specialist or expert auto locksmith. Like other automobiles, Peugeot keys are protected by an exclusive immobilizer system that requires the correct code to begin the engine. This is the reason why you should only choose a reputable Peugeot locksmith with the task of programming and creating the replacement.

Computers with faulty on-board computers

The on-board computer in your Peugeot is responsible for various functions in your car including power windows and airbags. The on-board computer will display the code when something goes wrong. This code will be saved in the system until the issue is fixed. Often, this will involve replacing the on-board computer.

The KeyLab of the most frequent causes of the airbag light coming on is loose or corroded connection in the airbag sensor. This could be due to wear and tear, aging, exposure to moisture and salt. It is crucial to get this issue addressed as quickly as possible, since an airbag that is malfunctioning can be risky in the event of an accident.





If you notice a card not found error on your Peugeot key fob, the battery inside the key fob might be dead or weak. This could prevent the key fob from transmitting a signal that will disable your vehicle's standard immobilizer. Try this by pressing the unlock key on the fob's key, then trying to start your vehicle. If it doesn't work the battery on the key is in need of replacement.